1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Problem using DM5 with Battery3

Discussion in 'Technical Issues - KOMPLETE (Archive)' started by grimepoch, Jan 10, 2008.

Thread Status:
Not open for further replies.
  1. grimepoch

    grimepoch Forum Member

    Messages:
    45
    I am not sure why, but on a fresh load of Battery3, even after mapping a drum trigger over to Battery, it does not play.

    What I have accertained using a controller keyboard and Midi Monitor is that the DM5 send a Note Off 0 message right after the Note On [Vel] message. Whereas the controller keyboard sends Note On [Vel] and then a Note Off [Vel2] on release that is almost the same as the Vel for the note on.

    So, I loaded up Addictive Drums and it works fine with the DM5 MIDI. So something in the way Battery3 is designed is causing it to behave this way.

    I tried looking through all the options, but I do not see any way to make it avoid the velocity setting of the Note Off messages.

    Any thoughts? Anyone else using a DM5 in their setup?
     
    grimepoch, Jan 10, 2008
    #1
Thread Status:
Not open for further replies.