1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE
NOTICE:

Our Traktor Pro Public Beta is available again in our new online community. Join us if you want to try new features.

MORE INFO

Push 2 Traktor & Ableton

Discussion in 'DJ Controllers' started by beachbum2001, 16/5/20.

  1. beachbum2001

    beachbum2001 New Member

    Messages:
    1
    I’ve mapped my push 2 to user in Traktor Pro 3 with full led feedback for the controls which works fine until I want to switch to live mode to control Ableton, when I go back to the user mode I’ve lost all led feedback. Is there a way to prevent this? I have all sync, remote etc set to off for the user port in live and the midi port in Traktor set to the user port. Searched online but not came up with anything useful
     
    beachbum2001, 16/5/20
    #1
  2. kaskone

    kaskone NI Product Owner

    Messages:
    81
    try to use open "midi monitor" and do rescan midi
    or go to "audio midi setup" and refresh there...

    can you share you TSI file for traktor ? curious to see LED feedback and i can test if it works same way for me and maybe debug your problem
    i am good in mapping but not motivated yet for push 2 mapping :))
     
    kaskone, 28/5/20
    #2
  3. ObviousAlias

    ObviousAlias New Member

    Messages:
    7
    Traktor has a command that you can map called Send Monitor State. This essentially resets your LEDs. I have it set to literally every modifier key I've mapped, both for the press and for the release, so my LEDs are always reflecting their correct state. I have not tried this with Push2 and switching back and forth from Ableton and the User mode mapped to Traktor, but I did use it for switching between Maschine 1/2/3 hardware in midi mode mapped to Traktor and Maschine running the Maschine software. I see no reason why it would not function the same way with Push.
     
    ObviousAlias, 27/11/20
    #3