1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Reaktor 5.6 MAC 64bit - No AU?

Discussion in 'REAKTOR' started by Siggi Mueller, May 26, 2011.

Thread Status:
Not open for further replies.
  1. Siggi Mueller

    Siggi Mueller NI Product Owner

    Messages:
    7
    "64-bit support for Windows and Mac OSX"

    installed the latest version but it doesn´t show up in Logic9 64bit. It only shows up in the 32bit folder with the AU Bridge. Did i missed something?

    siggi
     
  2. daveporter

    daveporter NI Product Owner

    Messages:
    186
    Set Logic to open as a 32 bit program. Start it and wait for it to scan for new plugins. Then quit logic. Now set Logic to open as a 64 bit program again. Restart logic and you should be able to find Reactor in your list of 64 bit programs.

    For some reason NI plugins don't scann well the first time in tbe 64 bit version of Logic.

    Hope this solves your problem.
     
  3. Siggi Mueller

    Siggi Mueller NI Product Owner

    Messages:
    7
    i did this. first starting L9 in 32bit and after scanning i´m starting L9 in 64bit. no success.

    The solution: starting in 32bit - go to the au manager - finding and select reaktor5 and reaktor5 fx - push the resest and rescan button. go back to 64bit. voila!
     
  4. Christian Provenzo

    Christian Provenzo Forum Member

    Messages:
    231
    Usually what Siggi said works for me but it didn't this time for some reason......once I did a REBOOT though on my imac 27 it was all good.......strange I had to do this though because the installer didn't ask me to reboot.....either way it's working now :p
     
  5. hellleutel

    hellleutel NI Product Owner

    Messages:
    16
    Hallo Siggi altes Haus :)

    Here it showed up just right, even without having to do the 32-Bit mode validation trick; so I was thinking that this s only necessary if you add new 32 bit plugins.
    no useful hint from my side except that it should be working.

    lg Uli
     
  6. Loopy C

    Loopy C NI Product Owner

    Messages:
    1,265
    Logic can be funny about these things under certain conditions. My first step is to remove the problematic plug-in, start Logic then quit, then move plug-in back and restart Logic again which is basically doing the same thing as what you did with the 'reset/rescan'. Just FYI.
     
Thread Status:
Not open for further replies.