1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Recording a mix using Komplete audio 6...

Discussion in 'NI Audio Interfaces' started by tomtaylor1990, Jun 9, 2012.

  1. tomtaylor1990

    tomtaylor1990 Forum Member

    Messages:
    26
    I'm wanting to record a mix from my DJM400 and cdjs into logic through the Komplete audio. What do I plug where? theres so many different sockets, any help would be much appreciated.

    thanks
     
  2. Mystic38

    Mystic38 NI Product Owner

    Messages:
    2,325
    you can use the rear sockets inputs 3,4 as your primary line level recording input.

    I save the front ones for more temporary use asn they are also more versatile... but if you want to capture two decks at once you can do so ..using all 4 inputs just make sure the input 1,2 are set to LINE.
     
  3. tomtaylor1990

    tomtaylor1990 Forum Member

    Messages:
    26
    Thanks for replying, there's only RCA on the back of the DJM are inputs 3 and 4 RCA? I thought they were all balanced
     
  4. AdventureMatt

    AdventureMatt New Member

    Messages:
    9
    Check out section section 7.3.4 of the Komplete Audio 6 manual booklet - its page 44.

    You will need to get some cables that run your DJM400 to the KA6 - RCA to 1/4" TRS. There is no RCA-in on the KA6. I believe for RCA inputs you would be looking at the Traktor Audio line up of interfaces.
     
  5. tomtaylor1990

    tomtaylor1990 Forum Member

    Messages:
    26
    right will do thanks