1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Recording Separate Limelite in Cubase SX3

Discussion in 'ELECTRONIC INSTRUMENTS 2 XT' started by BossLenz, Jun 20, 2005.

Thread Status:
Not open for further replies.
  1. BossLenz

    BossLenz NI Product Owner

    Messages:
    19
    Does anyone know how I might record the Bass, Snare, Hi-hat, Tie, and Pod on separate audio tracks in Cubase SX3?

    Thanx
     
    BossLenz, Jun 20, 2005
    #1
  2. flo_bielmann

    flo_bielmann New Member

    Messages:
    7
    I could not find any output channel settings in Limelite, thus I was not able to do it in one go. But I recorded hi-hat, bass etc. in separate tracks by just let e.g. the hi-hat play (set all other to mute in limelite). Then make audio mixdown. Repeat it for each instrument and you have several audio channels.

    Maybe this procedure requires that you first setup a separate output bus for limelite in Cubase (actually, to mute all other tracks in Cubase before doing audio mixdown should be sufficient).
     
    flo_bielmann, Jun 20, 2005
    #2
  3. PulCzar

    PulCzar Forum Member

    Messages:
    367
    That would be really nice if we could do this! I'll keep checking in case someone figures this out.
     
    PulCzar, Jun 20, 2005
    #3
Thread Status:
Not open for further replies.