1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Routing audio from Maschine to Logic-question about levels

Discussion in 'MASCHINE Area' started by michael m sabet, Aug 26, 2021.

  1. michael m sabet

    michael m sabet New Member

    Messages:
    6
    I'm routing my audio clips from Maschine into logic. I'm gonna adjust the individual levels of all my sounds so i can mix them in logic in their individual tracks. My question is, what should my master volume be at? I instinctively have it set at 0.0 db right now, but I was wondering if anyone here had any particular rule of thumb they had before printing the audio files for mixing in DAW.

    Thanks
    michael
     
    michael m sabet, Aug 26, 2021
    #1
  2. D-One

    D-One Well-Known Member

    Messages:
    10,075
    As long as it doesn't clip or isn't so low where boosting it in the DAW would noticeably raise any noise floor you're fine IMHO.
     
    D-One, Aug 26, 2021
    #2