1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Routing to direct out 1 doubles the signal!

Discussion in 'Feature Suggestions' started by NIMichi, Sep 5, 2013.

  1. NIMichi

    NIMichi NI Product Owner

    Messages:
    387
    If I route a signal to direct out 1, it is outputed at the master, not at the direct out 1. This channel not even exists...

    Furthermore it would be nice if there is a little display which shows the selected output below the busses and on the main page of a cell.
     
    NIMichi, Sep 5, 2013
    #1