Saving calibration date for Pitch CV Out block

Has anyone else had any luck saving calibration date of external oscillators when using the Pitch to CV block? It doesn't seem to be saved when I save the block as an instrument, and sometimes seems to get lost when I reopen a project. It sure would save a lot of time to be able to load calibration files like you can with the Silent Way voice controller when building instruments with multiple oscillators.

 

Thank you mbira for posting this. Exact same question here. It took quite a while to figure out how to calibrate the Blocks Pitch CV Out running Reaktor 6 as a plug-in in my Bitwig DAW. After successfully calibrating, I tried to store the snapshot. Pitch CV is an instrument, and I think instrument snapshots only save when the ensemble that they are in is saved, is that correct? If so, that's a bit of a hassle, but I'll just create an ensemble "template" for when I want to control the modular.

Thoughts anyone? Can instrument snapshots be stored/saved without saving an ensemble? (I'm now going to re-read the main manual... )

 

Hi. you can save calibrations as a snapshot with in the block Pitch cv out(instrument) See screen shot.
you will need to make the snapshots visible in the block header, then make sure you have the block selected at the top of the snapshot window(you might also find switching off instrument follow helpful) and save snapshot as normal.Remember to save the block so when you load the block in again it has the new calibrations,also if it is part of a bigger ens then save that also.
hope this helps

 

Thank you mpl! Your instructions were perfect. I'm a little rusty on Reaktor, missed saving the calibrated Pitch CV as a user instrument. That was the trick. Also helped your explanations of saving snapshots. This is still a grey area for me... snapshots, presets, in ensembles and in instruments.

 

I had problems calibrating the CV out module too, until I realized I need a hardware instrument device before Reaktor 6 on the track.