1. Please do not install macOS 10.15 Catalina yet, as Native Instruments software and hardware products are not supported under macOS 10.15 yet. For more info, please go HERE!
    Dismiss Notice

Solved Stop on note off

Discussion in 'KONTAKT' started by airflamesred, Jul 9, 2019.

  1. airflamesred

    airflamesred NI Product Owner

    Messages:
    312
    Just trying to fine tune a tambourine patch and want the 'shakes' to stop on note off, and then have the option of adding a hit. Where would I be looking.
    Thanks
     
  2. David Das

    David Das Moderator Moderator

    Messages:
    7,042
    It depends on how the specific patch is programmed. Clearly whoever programmed it programmed it to continue shaking past the end of note off, perhaps via a flex-env or specific AHDSR settings, which you could try editing.
     
  3. airflamesred

    airflamesred NI Product Owner

    Messages:
    312
    Curiously, one of the nki does operate as I would like and there does seem to be a lot of inconsistencies in the programming.
    Turning the release down doesn't work.
    There are no release samples.
    I was thinking along the lines of something in the wave editor?
     
  4. EvilDragon

    EvilDragon Moderator Moderator

    Messages:
    15,215
    Are you talking about a patch from factory library?
     
  5. airflamesred

    airflamesred NI Product Owner

    Messages:
    312
    No, Wavesfactory, Sharine.
     
  6. airflamesred

    airflamesred NI Product Owner

    Messages:
    312
    My bad. Turning the release down did the trick. You just have to remember to select the correct group. Schoolboy error there folks!