1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

switches values

Discussion in 'Building With Reaktor' started by Jeeboo, Aug 16, 2010.

Thread Status:
Not open for further replies.
  1. Jeeboo

    Jeeboo Forum Member

    Messages:
    39
    Hi!
    I'd like to know if there's a way to get a switch value.
    I'd like ti send values to the panel index (for stacked macros) depending on a switch position.
    For ex with a 3 way switch, if in 2 is selected, then I can get 2 as an output somewhere to feed the panel index.

    I didn' t find out a simple way to do that (I'm just starting with reaktor)

    thanks! :)
     
    Jeeboo, Aug 16, 2010
    #1
  2. herw

    herw NI Product Owner

    Messages:
    6,421
    yes very simple:
    use internal connections to get the status. just add a knob (you can hide it and connect its out to the panel index)

    switch status.jpg

    • add knob and change its properties (range, stepwidth etc.)
    • change to switch properties and click on send-button
    • change to knob properties and click on receive-button
    that's all. Bottom button is number 1!

    ciao herw
     
    herw, Aug 16, 2010
    #2
  3. Jeeboo

    Jeeboo Forum Member

    Messages:
    39
    WOOT! :lol:
    great, thank you!
     
    Jeeboo, Aug 16, 2010
    #3
Thread Status:
Not open for further replies.