Traktor pro 1.2 problem with BCD3000 asio soundcard

Hi everyone
I've installed yesterday the new version of traktor pro, and when I connected my bcd3000, traktor read only bcd3000(2in, 2 out)and not read the bcd3000 asio soundcard, the option with monitor & master out.
Anyone know how it can be resolve this problem?

thank u so much

ale

 

if recognized by it, you can have a try to ASIO4ALL but I'm not sure about it.

 

there isnt asio4all...in previous version traktor read asio4all, this version will not read anything...****

 

do you have it installed?

 

oh yes,i had installated the driver lots of time ago,and today i've reinstalleted this for try to resolve this problem,but it doesn't read the soundcard

 

Did you install the latest driver for the BCD3000? Version 1.2.0.0?

 

I had the exact same problem when I upgraded. You have to manually install the latest driver for the BCD3000 as Windows thinks the older driver version is the best. Once I forced the driver upgrade and rebooted everything was fine again.

 

what did you do DCJ?i may reinstall the driver and reboot the pc?

 

I went into the device manager and updated the driver there. I used the option choose the drivers manually and made it use the driver that I downloaded from Behringer. It says that the older driver is the best match but you need it to load the newer driver to solve the problem. You just keep going through all of the warnings until it finishes and then reboot the system.

 

Thank u so much...tomorrow i will try it...

 

another one that know something?

thanks

 

Were you able to update the driver to the latest version? What brand and model of computer are you running. Also, what OS and service pack are you using?

 

I don't find the device manager where i can install the driver...i use a dell inspiron 320 with 2gb RAM & windows xp s.p.2