[TRAKTOR PRO] BCD3000 midi learn problem

Hey all,


I have recently started using my old Behringer BCD3000 midi controller again and I really like the new Traktor (I've been using the old version ages ago, and must say that the GUI and the overal engine has improved big time!).

When I launched the program for the first time I loaded the default midimap from the settings (Controllers/Behringer/BCD3000) and everything worked fine. The only buttons that I found which have "no use" are the FX controls on the top (the buttons plus the knobs).

I would like to control the 2 filters (deck A and B respectively) with two of these knobs. I opened the MIDI Controller Manager under preferences but I can't get the knobs to work. I have selected the filters in the assignment table, but if I use midilearn to detect the knobs Traktor doesn't seem to recognise them.


Any thoughts/ideas/help? Thanks in advance!

P.S.: I can't get the headphones to work either! Everything is connected trough USB but when I plug in some headphones the only output I get (if I turn the phones vol. way up) is some noise. I cued the decks, played with the mix, the vol, the aux etc in Traktor but I just can't get any audio from my headphones.


Thanks in advance!

Greetings,

 

I hope I posted this in the correct category, otherwise maybe an admin can move this topic? Thanks.

 

Could anyone please help me?

 

i dont know about the "specialities" of this device. if no one jumps in here, pls check the behringer forum.