Turn Muted notes off - Scarbee Bass ?

Is there a way to turn 'mute' notes off for all scarbee basses please?
Its very anoying to hit the keys so hard every time to prevent unwanted muted notes

 

wish there was a solution for this. It appears every single Scarbee Bass that's chosen created muted effects vs. whole notes. Thanks

 

use the "Change Velocity" script and set the Min velocity to 40, (thats the min velocity for Jay-Bass, before mutes did not check other libs) you can do this at the KSP level or within the script editor of the instrument,,,just pick an empty script tab, but must be before the Main Script. (KSP preset is found under Factory -> Transform. Instrument script is found under Factory - > Randomize & Change

 

Greetings, I had created a separate template as you'll note in the image. Went under Factory | Randomize & Change, clicked the Script Editor found the Factory script and changed the Velocity from 100-109 to 40-109 then chose Save. I do hope I've done this correctly as I was in my own Scarbee Bass template. if incorrect might you please advise where I've gone wrong. Didn't quite understand the Empty Tab action though I did see a few Empty Tabs before the Main Script but no Save As option only a Save after modifying the Factory Script. Also, I found by hitting the keyboard notes a bit harder was helpful to obtain full notes and changing the Root note to A-1 (first note was A-1 in my riff) were of added benefit. Many thanks for the help.

 

Additional solutions would be: opening up the MIDI track and locating where there's muted notes. They seem to be where overlap exists into an adjoining note. separating the two notes allows for Scarbee to play naturally. I also chose a preset called: pop and country. by Default, I recall seeing the velocity range is 70-79. A few images attached.

 

Overlapping notes trigger Hammer-on and pull off articulations not muted notes...see section 4.2 of the manual...

 

Excellent, thanks for this clarification on terminology and pointer to the manual