Turning off FX on track load

I often will use Delay FX To do a Echo loop out to end a mix. When i do this the FX is still active even after loading the a new track. thus having to turn off the FX before i can do anything.

Is there i way where i can have the FX turn off upon loading a track?

Note I have both Reset Deck & Reset mixer controls checked under loading/resetting Controls in preference. Looks like the effects are not considered a mixer or deck control.

 

you can add this command (set fx off) to the "load into deck" command for each deck.

 

Tom,

Thanks for the reply. I a bit new to the midi mapping...i can't seem to find where i change or add this info?

 

Go to settings, controller manager, add-in, (now I'm lost, but there should be something about FX and activate/deactivate)

Then hit LEARN and push the button you also use for loading your track. Push LEARN again.

Done

 

So this would work only if i used a load button to load a selected track but what if i drag and drop my tracks on the decks?

 

Then you would probably need to select a different button (keyboard key?) to switch views.

 

Sorry guys... i could not find anything in the add in that is close to (set fx off) or "load into deck"?

 

http://s1.bild.me/bilder/160512/3523730Bildschirmfoto_2012-10-23_um_20.18.03.png

 

Add in > Deck common > Load selected
Add in > FX unit > Unit on / type-button / mode-direct / value-0

Map it to same button

 

Thanks guys this works well. If i use the a button to load the tracks.

Is there a way i can do this if i drag and drop a song for the load?

 

i guess what i am looking for is a way no matter how the track loads either drag and drop or load button that will trigger a command.

So the command trigger would not be a push of a button but the actual function of a track load.