1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

using aftertouch to control LFO amount

Discussion in 'MASSIVE + MASSIVE X' started by n8tron, Sep 3, 2010.

Thread Status:
Not open for further replies.
  1. n8tron

    n8tron NI Product Owner

    Messages:
    33
    I can't figure this out for some reason and I'm sure it's obvious...

    Say pitch for example, so I can hit a note and press down and get vibrato. On other synths I set the LFO to modulate the pitch then set aftertouch to control the LFO. I can drag the LFO to the pitch mod slot and get that going, but I just can't figure out how to get aftertouch to control the amount. I figured you dragged the aftertouch mod at the bottom middle to the source slot of the pitch but that doesn't seem to work.
     
  2. ew

    ew Moderator Moderator

    Messages:
    21,328
    That's what you use the mod slots with the SC on top for. Those are for scaling the other modulation.
    Conversely, if you're just using the vibrato LFO (the osc tab), just put the AT in the depth modulation slot.

    ew
     
  3. n8tron

    n8tron NI Product Owner

    Messages:
    33
    oh... that's a shame, I like using aftertouch.
     
  4. ew

    ew Moderator Moderator

    Messages:
    21,328
    ?

    You still are by doing what I'm talking about :~

    ew
     
  5. n8tron

    n8tron NI Product Owner

    Messages:
    33
    you must have edited your post... when I looked before your post said that you thought the LFO depth was hardwired to the mod wheel...

    I'll try out what you now suggested
     
  6. ew

    ew Moderator Moderator

    Messages:
    21,328
    I had put that earlier; I thought I was in the Maschine forum for a moment. However, I edited it way before you had reposted; I changed that within a minute or two after posting.

    ew
     
Thread Status:
Not open for further replies.