VCI-100 1.3 Firmware bug?

Discussion in 'DJ Controllers' started by dj_smex, Feb 15, 2009.

Thread Status:
Not open for further replies.
  1. dj_smex

    dj_smex NI Product Owner

    Messages:
    207
    Hi, just done the firmware upgrade to 1.3 on my VCI-100 and have noticed that the 4th button in from the left above the left jogwheel, takes 2 clicks to activate. However, when booting in firmware 1.2, this same button only takes 1 click.

    Anyone else get this?

    I've also had my VCI lockup while using the FX section and have to switch the unit off/on to resume normal use.

    I'm hoping I've not damaged the unit while performing the upgrade.
     
  2. Sheph

    Sheph New Member

    Messages:
    10
    The left "sync" button is working correctly. it was done that way because the function it was designed for when 3.4 came out only had "hold" instead of "Toggle." simple fix, make the firmware do the toggling. press it once and it is on. press it again and it is off. you can see this happen with a midi signal intercepter such as midipipe or midiox.

    the fact that it is locking up is not part of the upgrade. I'm not sure what's going on there... mine works fine.

    S.
     
Thread Status:
Not open for further replies.