Vel to cutoff

How do you apply velocity to cuttoff?

P.S. Are the menu buttons and text panels skinable?

 

Midi In/Gate module's output is either 0 (note off) or a number between 0 and 1 (note on).

So you can send the output of this module into the input of an Event/Separator module, with nothing wired to its "threshold" input. Now, the High output of this module will be only the values that are greater than zero - the MIDI In/Gate module's note on values.

Now, you can use a Math/Multiply module to multiply your value between (just above) 0 and 1, maybe by 100, and the result of that calculation can be fed into the P input of a filter.

...And then you can play with making the "multiply by" value into a Panel knob; and/or adding the result to some base value for the cutoff, controlled by another panel knob; and/or wiring the Midi In/Gate module's output to the Trig/G input of an envelope, then multiplying the envelope's output by some value and passing the result into a filter's P input...

 

so it's just:

gate x 100 into P input.

Thanks, Ill try that.

 

That's a starting-point, but only a starting point. Once you get it working with a Math/Constant of 100, replace that constant with a knob whose range is 0 to 100 (or -100 to 100)... and start mixing that with other values, like LFOs, the pitch of the note, and other constants...