1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

velocity problem triggering Battery with Maschine pads in Cubase

Discussion in 'MASCHINE Area' started by dkean1, Jun 18, 2009.

Thread Status:
Not open for further replies.
  1. dkean1

    dkean1 NI Product Owner

    Messages:
    9
    I'm using Maschine as a midi input in Cubase in Control mode to trigger Battery 3. Everything is fine using the Battery template in Maschine - the midi signal is received by Battery but when I hit a pad the velocity output is very low.
    Tried increasing vel sensor in Maschine and Half Vel / Full Vel buttons but no change.
    Any suggestions.
    Thanks
    DK
     
    dkean1, Jun 18, 2009
    #1
  2. ew

    ew Moderator Moderator

    Messages:
    21,328
    Welcome =)

    What do you have set for scaling in your preferences under hardware? Try one of the softer settings and have the sensitivity up.

    Or, you could go into the settings for each pad and see if the full range is there, and compress the range there if you want.

    ew
     
    ew, Jun 18, 2009
    #2
  3. koranek

    koranek NI Product Owner

    Messages:
    36
    Actually, go into the controller editor and look to see what the hardware controller settings are for the Battery template. Each template has a different set of velocity curves that are associated with that template. These can be different for what you set for the hardware through Maschine. Make your changes there and save it with the template.

    This frustrated me for a long time because I would set up Maschine perfectly, but lose the settings when I switched to Midi control mode. Now all is beauty and light:).
     
    koranek, Jun 18, 2009
    #3
Thread Status:
Not open for further replies.