1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE

Very simple question

Discussion in 'KONTAKT' started by sevaels, May 5, 2004.

Thread Status:
Not open for further replies.
  1. sevaels

    sevaels New Member

    Messages:
    23
    Hey guys,

    I was wondering if it was possible to sweep the a full knobs values. By this i mean sweeping the entire knob left and right using automation.

    If i set up automation for a certain parameter and put the level to 100 or -100 i notice that it dosn't sweep the whole knobs potential values. Is tehre a way so that far left on my physical knob is far left on kontakts and full right on my physical knob is full right on kontakts?

    Hope i explained it ok =D

    Thanks, Sevaels
     
    sevaels, May 5, 2004
    #1
  2. Marc JX8P

    Marc JX8P NI Product Owner

    Messages:
    21
    What host software are you using for automation?
     
    Marc JX8P, May 9, 2004
    #2
  3. sevaels

    sevaels New Member

    Messages:
    23
    hey

    Hey, thanks for replying!

    I'm using Logic 6.

    Anyone know if theres a way to get full roation of the knobs?

    Thanks, Sevaels
     
    sevaels, May 10, 2004
    #3
Thread Status:
Not open for further replies.