Vestax VCI-100: removing touch detection of jog dial (tks or mapping)

Discussion in 'TRAKTOR 3' started by dj_funkbomb, Mar 21, 2010.

Thread Status:
Not open for further replies.
  1. dj_funkbomb

    dj_funkbomb Forum Member

    Messages:
    29
    I am using Traktor 3.4 with my Vestax VCI-100 since it seems to run more stable on my old laptop.

    I would prefer the metal of the jog dial (the touch sensitivity) to do the following:
    - when not in vinyl mode, I would like the whole wheel to be a pitch bend
    - so, the touch dial must NOT perform a SEEK, it must behave just as if I was touching the outside clear edge of the jog dial

    The reason is that my fingers often brush the metal when I'm mixing, so the track SEEKS far ahead instead of just pitch bending like I want it to.

    I have tried to map the MIDI but I can't figure it out.

    Please can someone offer me some help? A TKS file, or instructions, or advice.

    Thanks
     
  2. chachakoala

    chachakoala NI Product Owner

    Messages:
    449
    if your vci-100 is version 1.2 and you push the two vynyl mode buttons at the same time, then the jogs will be completely disabled. Otherwise, you could either delete the two scratch commands or disable the scratch on command by adding a modifier condition (M1=1 for example)
     
Thread Status:
Not open for further replies.