Xone 1D will only Play but not Pause TSP.

Just picked up a Xone 1D and have been getting the majority of the basic functions to work. (Sync, Focus, Set to Master, etc.) However I have been having a difficult time with just the Play/Pause function. When I assign the Play/Pause function to a button it will only Play but won't pause. Also I am having a similar problem with the "power on setup" jogwheel. Ideally I would push the knob down and the tracklist would pull up and then I would push it again to go back to the original screen with the decks, but the knob will only pull up the tracklist page and won't return to the original screen when the knob is pushed again. What am I missing?

Tools:
Traktor Scratch Pro
Audio 8 Sound card
Xone 1D
DJM-700

 

Set the play/pause button to TOGGLE

Power on setup Jogweel? Try setting to Toggle again, or gimme more info.

 

Thank you for your advice. I did have some luck on deck A after switching to Toggle. Seemed like an easy fix that I should have figured out. However when I duplicated my settings for deck A and tried the same on deck B it won't play. I assigned a different button to deck B, but had no luck. All of the settings are exactly the same as deck A but no dice so far. I really appreciate you taking time to help. Thanks.

 

Give all info of the command that is not working.

Is it referenced to deck B? Modifier on? Shift button?

 

Now I am trouble having Deck A work. Set on note D2 (ch. 16) Lock Omni is not checked. Set to Toggle and Button M1 or M2 Modifier are not set. I have tried many different settings but have had no luck. Also invert is not selected. I am trying to assign the play/pause buttons to the 4 buttons on the very bottom of the 1D controller.

Not to sound like a complete idiot but I am not sure what you mean by shift. Sorry and thank you in advance.

 

This is how it should look for Deck A:

Duplicate, en then program for B.

 

I set all of my settings to match the screen shot. It did not work. I am using Traktor Scratch Pro 1.1.2.004. Is there an update I didn't notice. My screen options didn't look exactly the same as what the picture looked like. Thanks again for your help.

 

I´m not sure, but can it depends from the Mode of the Xone1d (Abelton or Traktor) please check the manuel of the Xone....normaly the Play/Pause will work very fine!

 

The original drivers I downloaded seemed to throw something off on the xone controller. I ended up hooking the midi cable into the audio 8 soundcard and then turned off the midi input from the xone under MIDI setup so the only midi signal the computer gets is from the soundcard. Now everything works. Thanks again for your help!