1. IMPORTANT:
    We launched a new online community and this space is now closed. This community will be available as a read-only resources until further notice.
    JOIN US HERE
NOTICE:

Our Traktor Pro Public Beta is available again in our new online community. Join us if you want to try new features.

MORE INFO

Z2 FX buttons sticking.

Discussion in 'KONTROL Z2' started by Matthew Read, 19/12/21.

  1. Matthew Read

    Matthew Read New Member

    Messages:
    12
    Some of the small round buttons are sticking a bit, especially fx... Guessing it's just gunk... Before I open it up & tear it down.. Anyone know if these are soldered or Cable jack/jst connectors? Simple replacement? Diy?

    Or can you pop the button caps off and blow a bit of compressed air in?

    Don't really want to fk them up more than they are.. cheers for any advice before I butcher my mixer.
     
    Matthew Read, 19/12/21
    #1
  2. AlphA_ZA

    AlphA_ZA NI Product Owner

    Messages:
    30
    I had the same issue with my left Sync button. I first blew some compressed air along the sides of the button (after taking off the faceplate) then sprayed some circuit board cleaner and pressed the button repeatedly a couple dozen times. That was about 3 or 4 months ago and the button is still fine. Give it a shot.
     
    AlphA_ZA, 20/12/21
    #2
  3. Matthew Read

    Matthew Read New Member

    Messages:
    12
    Nice .. il get some and give it a blast.
     
    Matthew Read, 20/12/21
    #3