Z2´s knobs and faders unset while mixing with Technics MK 1200.

Hi,

I have a Z2 and 2 Technics MK 1200. I was mixing some vinyls (on phono mode without the computer on) and suddenly the whole mixer unset. For example, the Main knob doesn't do nothing, while the Filter knob now works as volume. Many other knobs stop working.

This is a worrying issue, can anybody help?

Thanks so much,

Ariel

 

Aditional information:

I have Windows 7
I have recalibrate the knobs on traktor.

 

File a support ticket. I have 2 Z2's and have never seen this happen. You might want to make a video of it. Also see if there are any firmware updates for your Z2.

 

Hey Irv, Yes this happend and somehow is working again. While having this problem I noticed that when moving the Booth knob, the whole mixer started working again. If anybody knows something about this please REPORT! thanks.

 

I also had another problem right now. I was recording a vinyl mix (i couldn't set up the decks for recording until i found an answer of yours in another post Irv, had to use live input on the deck, thanks for that). In the middle of the mix the volume suddenly rise very high, after some seconds it corrected by itself but the mix was ruined. I kept on mixing and after some time the same thing happened but the volume went down.

If anybody can help it would be nice,

A

 

I replied this before.

I also had another problem right now. I was recording a vinyl mix (i couldn't set up the decks for recording until i found an answer of yours in another post Irv, had to use live input on the deck, thanks for that). In the middle of the mix the volume suddenly rise very high, after some seconds it corrected by itself but the mix was ruined. I kept on mixing and after some time the same thing happened but the volume went down.

If anybody can help it would be nice,

A

 

When the volume went up did the master volume also go up or just the recording volume? I record all the time but, only using Traktor - no real vinyl.

Completely unrelated: if you are spinning vinyl how the latency and effects when using a live input? Also, if you don't use Snap & Quantize consider making them something else like bpm tap, record on/off or Auto bpm on/off.

 

No reply for this thread? Please any NI support?

 

This is not a support ticket. It's a forum for users. Open a support request.