This page is available in English only

Eventide Eclipse Control

Eventide Eclipse Program Select with 8 Modulation Knobs

(0 Votes)
1.0 (Updated 4 years ago)
November 02, 2015
Reaktor 5 or lower
Instrument Other


This modest ensemble allows for program selection and modulation of 8 user defined parameters.

(This assumes the Eclipse is set to Channel 1. If not you will have to change the channel constant in structure view.)

Set Reaktor's MIDI out to the port connected to the Eventide Eclipse.

On the Eclipse go to SETUP page #3. Select EXT1 and then press setup until "Capture" is displayed. Select capture and then move "Knob 1" in the Reaktor ensemble. Repeat for EXT2-EXT8.

To assign the EXT controls you just set up, navigate to the parameter of interest then press and hold the soft button until it says Modulate. Select the source (EXT1-EXT8).

The knob will now control that parameter in the Eclipse.

Don't forget to save your preset! I've created a User Bank for presets 0-99 that will recall presets 001-099 on the Eclipse.