1. Hi everyone,

    This forum is now closed for posting! If you require technical support from NI or have a questions about activating your product, please head over to our new Support Community!


    The Support Community is the new location where you can expect to receive assistance and feedback on technical support, sales or installation issues from our Support Agents and other users.

    Please also note, questions about the status of an order should always be directly sent to our Order Support team HERE.

    Best wishes, 
    The NI Team

Problems with Battery 3 and Trigger Finger

Discussion in 'Technical Issues - KOMPLETE (Archive)' started by djad05, Oct 7, 2007.

Thread Status:
Not open for further replies.
  1. djad05

    djad05 New Member

    Ok, I have tried everything I know to get this to work!

    I am simply trying to assign the pads on my Trigger Finger to interact with the cells in Battery 3.

    If you own a trigger finger or any M-Audio midi controller I am sure you know of Enigma. Enigma allows you to assign the parameters of your pads, knobs, sliders etc.... in order to use them with your software.

    In this case I have gone into Enigma and changed the note assignments to the coresponding cells in Battery 3. The Trigger Finger is set up. Upon tapping a pad it shows the velocity and then the note that has been assigned to the pad. So everything is good on that end.

    The problem here is that when I try to tap the pads they still do no corespond in Battery with the cells they are assigned to.

    Any ideas here?

    I am somewhat new to this so please explain things as simple as possible!

    Thanks so much in advance!
Thread Status:
Not open for further replies.